This will get stored in a safe place and I’ll also back these files up to the cloud. Then I emailed it to myself AND saved the MTC4.1.0 installer, pccplugin, and reg code to thumb drive. I was able to successfully reboot my nearly dead old laptop and pull the code out. If you have access to the computer you had Make the Cut installed on you can use these instructions to attempt to retrieve the registration code. According to several users on the forum, the user has not responded to anything on the forum for over 5 years at this point (writing this 12/2020). I also have not received an answer via their support ticket system. I used their automated system and it did not work. The forum and site are up now, I was unable to get any assistance from the owner for getting my reg key. The developer has allowed the site to come and go it is currently up and you can download the software, though there are reports in the forum that the new serial numbers no longer work. You also need to install the pccplugin which you have hopefully saved on a thumb drive somewhere. If you upgraded your copy of make the cut past MTC 4.1.0 it can’t be hacked to work. Eventually the software was locked down and the code needed to make the software able to work with the cricut was locked out. Googling the company shows several lawsuits. Make the Cut was tied up in court for years. Well that was fun, until Provocraft decided they didn’t want third party software controlling their machines. I was able to cut anything I wanted and items of my own designs. * "Cricut" is a trademark of Provo Craft & Novelty Inc.Way back in 2009 or even further back I picked up a copy of Make the Cut a fabulous software that let me control my Cricut craft cutter.
"USB Serial Converter" in your "Device Manager" under the "Universal Serial Bus controllers" Once the driver has been installed (or if you already have the driver installed), you should see any entry for If the driver was not found, you can download them here Windows should be able to find, download and install the correct driverĦ. Choose the option to allow Windows to search for the driver onlineĥ. Choose the option to "Locate and install driver software".Ĥ. If you do not get this, the driver may already be installed on your computer, and you should see the entires in your "Device Manager" as in the screenshot at the bottom of this page.ģ. If you do not have the driver installed, Windows will indicate that is has "Found New Hardware", and should prompt you to install a driver. Connect your Cricut™, Pazzles Inspriation™ Black Cat Cougar/Lynx™ or USCutter™ machine to your computer and turn cutting machine onĢ.
In order for "Sure Cuts A Lot" to work with certain cutting machines on a Windows machine, you will need to have the correct driver installed.ġ.
0 kommentar(er)
